Inspection Mode 3
WARNING: This page is about a different variant/trim than selected.
| Code | Note | Number of driving cycles on the detecting condition |
|---|---|---|
| P0A0011 | - | 1 |
| P0A0015 | - | 1 |
| P0A6012 | - | 1 |
| P0A6014 | - | 1 |
| P0A601C | - | 1 |
| P0A601F | - | 1 |
| P0A6312 | - | 1 |
| P0A6314 | - | 1 |
| P0A631C | - | 1 |
| P0A631F | - | 1 |
| P0AED11 | - | 1 |
| P0AED15 | - | 1 |
| P0BCC11 | - | 1 |
| P0BCC15 | - | 1 |
| P0C3811 | - | 1 |
| P0C3815 | - | 1 |
| P0C3D11 | - | 1 |
| P0C3D15 | - | 1 |
| P0E5111 | - | 1 |
| P0E5115 | - | 1 |
| P0E511F | - | 1 |
| P0E5811 | - | 1 |
| P0E5815 | - | 1 |
| P155911 | - | 1 |
| P155915 | - | 1 |
Diagnostic procedure:
- Using the Subaru Select Monitor, perform the clear memory of [P-HEV Drive Motor]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Turn to IG OFF, and wait for two minutes or more.
- Using the Subaru Select Monitor, read the DTC of [P-HEV Drive Motor] to check that there is no DTC displayed. Ref. to P-HEV DRIVE MOTOR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1.
- Turn to IG ON, and wait for five seconds or more.
- Read the [Readiness code] of [P-HEV Drive Motor] using Subaru Select Monitor and check that the concerned self-diagnosis is completed. Ref. to P-HEV DRIVE MOTOR (DIAGNOSTICS)>ALL READINESS DIAGNOSTIC CODE(S) .NOTE: If the concerned DTC is displayed, the self-diagnosis of the DTC is not complete, repeat from step 4.
However, even if the DTC codes P0A601F, P0A631F and P0E511F are displayed, proceed to the next step if any other DTCs are not displayed. - Using the Subaru Select Monitor, read the DTC of [P-HEV Drive Motor] to check that there is no DTC displayed. Ref. to P-HEV DRIVE MOTOR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
NOTE:
If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.