DTC U0100-87: Lost Communication With ECM/Pcm "A" Missing Message: Notes

WARNING: This page is about a different variant/trim than selected.

1. -

Detecting condition:

Malfunction of CAN communication with ECM (CAN system malfunction)

(1 trip detection logic)

Trouble symptom:

Normal driving

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to P-HEV DRIVE MOTOR (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION .

Courtesy of SUBARU OF AMERICA, INC.

CHECK DTC .

Read the DTC of [P-HEV Drive Motor] using the Subaru Select Monitor. Ref. to P-HEV DRIVE MOTOR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

NOTE:

Related DTC
P312487	LOST COMMUNICATION BETWEEN DRIVE MOTOR "A" AND HV ECU MISSING MESSAGE

Are any DTCs listed in reference above displayed?

Yes: Perform the diagnosis of DTC P312487. Ref. to P-HEV DRIVE MOTOR (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P312487 LOST COMMUNICATION BETWEEN DRIVE MOTOR "A" AND HV ECU MISSING MESSAGE .

NOTE: DTC U010087, U029387 or U117087 may be output due to a malfunction that outputs DTC P312487. Check DTC P312487 first, and then perform the reproducing test to check that the DTC is not output.

No: Check the CAN communication system. Ref. to LAN SYSTEM (DIAGNOSTICS) (HEV)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .