DTC P0340-31: Camshaft Position Sensor "A" Circuit Bank 1 Or Single Sensor No Signal: Notes
WARNING: This page is about a different variant/trim than selected.
Detecting condition:
While the engine is running, the statue without GI signal (camshaft position sensor) continues for 2 seconds or more.
(1 trip detection logic)
Trouble symptom:
Normal driving (vibration may occur at engine start → stop)
NOTE:
For the diagnostic procedure, refer to DTC P034000. Ref. to P-HEV DRIVE MOTOR (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P034000 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 1 OR SINGLE SENSOR .