Water Pump Pulley

WARNING: This page is about a different variant/trim than selected.

Using the ST1 and ST2, install the water pump pulley.
Preparation tool:

ST1: PULLEY WRENCH (18355AA000)

ST2: PULLEY WRENCH PIN SET (18334AA020)

Tightening torque:

14 N.m (1.4 kgf-m, 10.3 ft-lb)
Install the V-belts. Ref. to MECHANICAL (H4DO (EXCEPT FOR HEV))>V-BELT>INSTALLATION>HYBRID MODEL>V-BELT .