Engine Coolant (Inverter Assembly Side)

WARNING: This page is about a different variant/trim than selected.

CAUTION:

The engine coolant is pressurized when it is hot. Wait until engine coolant cools down before proceeding the work.
If the engine coolant splashes, completely remove and clean it.

NOTE: The SUBARU Super Coolant contains anti-freeze and anti-rust agents, and is especially made for Subaru engines with an aluminium cylinder block. Be sure to use SUBARU Super Coolant, since other coolant may cause corrosion.

Engine coolant:

Refer to "RECOMMENDED MATERIALS" for engine coolant. Ref. to RECOMMENDED MATERIALS .

Engine coolant concentration:

Refer to "ADJUSTMENT" for the recommended engine coolant concentration. Ref. to COOLING (H4DO (HEV))>ENGINE COOLANT>ADJUSTMENT .

Park the vehicle on a level surface.
With the engine in a cold condition, check that the engine coolant level of the inverter tank lies between "FULL" and "LOW", and add the engine coolant if the coolant level is low.

NOTE: If it is necessary to add the coolant, make sure that there are no engine coolant leaks.