LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (HVAC System (Heater, Ventilator And A/C) (HEV)) >> Solenoid Valve >> Removal >> Low Pressure Solenoid Valve

Low Pressure Solenoid Valve

WARNING: This page is about a different variant/trim than selected.
  1. Using the refrigerant recovery system, discharge refrigerant. Ref. to AIR CONDITIONER (HEV)>REFRIGERANT RECOVERY PROCEDURE>PROCEDURE .
  2. Disconnect the ground terminal from battery. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Remove the bumper face - front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT BUMPER>REMOVAL .
  4. Disconnect the pipe - evaporator cooling and hose - pressure suction valve.
    1. Remove the bolt and disconnect the pipe - evaporator cooling and hose - pressure suction valve.
      CAUTION: Seal the engaging parts of the disconnected pipe, hose and LOW solenoid valve with plugs or vinyl tape to prevent foreign matter from entering.
      G13234301Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the LOW solenoid valve.
    1. Disconnect the connector.
    2. Remove the bolts and remove the LOW solenoid valve.
      CAUTION: Seal the engaging parts of the disconnected condenser assembly and LOW solenoid valve with plugs or vinyl tape to prevent foreign matter from entering.
      G13234302Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals