Low Pressure Solenoid Valve
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Replace the O-rings with new parts, and then apply compressor oil to install completely.
- Install the LOW solenoid valve.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the pipe - evaporator cooling and hose - pressure suction valve.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the bumper face - front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT BUMPER>INSTALLATION .
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
- Charge refrigerant. Ref. to AIR CONDITIONER (HEV)>REFRIGERANT CHARGING PROCEDURE>PROCEDURE .