LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (HVAC System (Heater, Ventilator And A/C) (HEV)) >> Pressure Sensor >> Installation

Pressure Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Apply compressor oil to O-rings of the sensor and install it completely.
  1. Install the new pressure sensor.

    Tightening torque: 

    10.8 N.m (1.1 kgf-m, 8.0 ft-lb)

  2. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Charge refrigerant. Ref. to AIR CONDITIONER (HEV)>REFRIGERANT CHARGING PROCEDURE>PROCEDURE .
scientia non olet · About LEMON Manuals