LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (HVAC System (Heater, Ventilator And A/C) (HEV)) >> Hose and Pipe >> Removal >> Low-Pressure Hose

Low-Pressure Hose

WARNING: This page is about a different variant/trim than selected.
  1. Using the refrigerant recovery system, discharge refrigerant. Ref. to AIR CONDITIONER (HEV)>REFRIGERANT RECOVERY PROCEDURE>PROCEDURE .
  2. Disconnect the ground terminal from battery. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Remove the collector cover. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>COLLECTOR COVER>REMOVAL .
  4. Disconnect the hose - pressure discharge.
    1. Remove the bolts and remove the hose - pressure discharge.
      CAUTION: Use a plug or vinyl tape to seal the engaging parts of the disconnected hose and electric compressor assembly to prevent foreign matter from entering.
      G13234305Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the hose - pressure suction.
    1. Remove the bolts and remove the hose - pressure suction.
      CAUTION:
      • Do not apply excessive force to the hose.
      • Use a plug or vinyl tape to seal the engaging parts of the disconnected hose and electric compressor assembly to prevent foreign matter from entering.
      G13234306Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals