LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (HVAC System (Heater, Ventilator And A/C) (HEV)) >> Hose and Pipe >> Installation >> Low Pressure Valve Hose

Low Pressure Valve Hose

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Replace the O-rings with new parts, and then apply compressor oil to install completely.
  • If the hose and pipe has been replaced, add an appropriate amount of compressor oil to the compressor. Ref. to AIR CONDITIONER (HEV)>COMPRESSOR OIL>ADJUSTMENT .
  • When connecting hoses, do not apply an excessive force to them. After installing, check that no torsion or excessive tension applied to the hoses.
  1. Install the hose - pressure suction valve.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  2. Install the radiator assembly. Ref. to COOLING (H4DO (HEV))>RADIATOR>INSTALLATION .
  3. Install the bumper face - front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT BUMPER>INSTALLATION .
  4. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  5. Charge refrigerant. Ref. to AIR CONDITIONER (HEV)>REFRIGERANT CHARGING PROCEDURE>PROCEDURE .
scientia non olet · About LEMON Manuals