LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (HVAC System (Heater, Ventilator And A/C) (HEV)) >> Control Panel >> Inspection

Control Panel: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Check the illumination operation when battery voltage is applied between the connector terminals.
    CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
    Incorrect polarity connection may cause LED damage inside the switch.
    G10309163Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Inspection conditions Specification
    8 (+) - 2 (-) Apply battery voltage. Light ON
  2. If it does not operate normally, replace the heater control assembly.
scientia non olet · About LEMON Manuals