LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Brake Control System (Diagnostics) (HEV)) >> Inspection Mode >> Procedure >> VDC System

VDC System

WARNING: This page is about a different variant/trim than selected.
  1. Using the Subaru Select Monitor, perform the clear memory of [Brake Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
  2. Drive the vehicle at least ten minutes. (Reproduce nearly the same condition as occurred when the DTC was recorded.)
    NOTE: Make sure the vehicle is not dragged to one side under usual driving condition.
scientia non olet · About LEMON Manuals