DTC C1362: Normal Closing Valve 2

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition:

A fault is detected if electrical malfunction judgment is generated for VDCH/U solenoid valve.

Trouble symptom:

ABS does not operate.
EBD does not operate.
VDC does not operate.
Hill hold does not function.
EyeSight does not operate.

Wiring diagram:

Vehicle dynamics control system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>VEHICLE DYNAMICS CONTROL SYSTEM .

Courtesy of SUBARU OF AMERICA, INC.

CHECK VDC CONTROL MODULE & H/U INPUT VOLTAGE .
1. Turn the ignition switch to OFF.
2. Disconnect the connector from the VDC Control Module & H/U.
3. Run the engine at idle.
4. Measure the voltage between VDC Control Module & H/U connector and chassis ground.
  Connector & terminal
  
  (B310) No. 1 (+) - Chassis ground (-):
  
  (B310) No. 30 (+) - Chassis ground (-):
  
  (B310) No. 35 (+) - Chassis ground (-):
  
  Is the voltage 10 - 15 V?
  
  Yes : Go to 2.
  
  No : Repair the power supply circuit including the battery.
CHECK VDC CONTROL MODULE & H/U GROUND CIRCUIT (CHECK FOR OPEN CIRCUIT) .
1. Turn the ignition switch to OFF.
2. Measure the resistance between VDC Control Module & H/U connector and chassis ground.
  Connector & terminal
  
  (B310) No. 14 - Chassis ground:
  
  Is the resistance less than 10 Ω?
  
  Yes : Go to 3.
  
  No : Repair the VDC Control Module & H/U ground harness.
CHECK POOR CONTACT OF CONNECTORS .
Is there poor contact of connector between generator, battery and VDC Control Module & H/U?

Yes : Repair the connector.

No : Go to 4.
CHECK VDC CONTROL MODULE & H/U .
1. Connect all connectors.
2. Using the Subaru Select Monitor, perform the clear memory of [Brake Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
3. Execute the inspection mode. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>INSPECTION MODE .
4. Read the DTC of [Brake Control] using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .
  Is the same DTC displayed?
  
  Yes : Replace the VDC Control Module & H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U) .
  
  No
Go to 5.
CHECK DETECTION OF OTHER DTCS FOR VDC .
Read the DTC of [Brake Control] using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

Is any other DTC displayed?

Yes : Perform the diagnosis according to the DTC. Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>Diagnostic Trouble Code (DTC)>LIST .

No : Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.