LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Manual Transaxle & Differential (5MT)) >> Transmission Mounting System >> Removal >> Crossmember And Cushion Rubber

Crossmember And Cushion Rubber

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Lift up the vehicle.
  3. Remove the crossmember support - rear.
    G11256105Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the front exhaust pipe. Refer to EXHAUST (H4DO (EXCEPT FOR HEV))>FRONT EXHAUST PIPE>REMOVAL .
  5. Remove the center exhaust cover.
    G11254834Courtesy of SUBARU OF AMERICA, INC.
  6. Set the transmission jack.
    CAUTION: Always support the transmission case with a transmission jack.
    G08318897Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the front crossmember and the rear crossmember.
    G11256143Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the transmission cushion rubber.
scientia non olet · About LEMON Manuals