Transfer Driven Gear: Assembly

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Using the ST, install the taper roller bearing (transfer case side).
CAUTION:
- Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
- Be careful when handling, because the outer race and inner race of the taper roller bearing are used as a set.
Preparation tool:

ST: INSTALLER (927640000)

Courtesy of SUBARU OF AMERICA, INC.
Using the ST1 and ST2, install the taper roller bearing (extension case side).

CAUTION:

Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
Be careful when handling, because the outer race and inner race of the taper roller bearing are used as a set.

Preparation tool:

ST1: INSTALLER (498175500)

ST2: REMOVER (899864100)

Courtesy of SUBARU OF AMERICA, INC.