LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Manual Transaxle & Differential (5MT)) >> Reverse Check Sleeve >> Installation

Reverse Check Sleeve: Installation

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the reverse check sleeve.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

    G10323002Courtesy of SUBARU OF AMERICA, INC.
  2. Install the reverse check ball, reverse accent spring, new gasket, and plug.

    Tightening torque: 

    9.75 N.m (1.0 kgf-m, 7.2 ft-lb)

    G10323003Courtesy of SUBARU OF AMERICA, INC.
  3. Install the shifter arm.
    NOTE: Apply transmission gear oil to the oil seal lips.
    G10322971Courtesy of SUBARU OF AMERICA, INC.
  4. Install the transfer case together with the extension case assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>INSTALLATION .
  5. Install the manual transmission assembly to the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
scientia non olet · About LEMON Manuals