Turbine Speed Sensor: Installation

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.

Install the turbine speed sensor.
NOTE:
- Use new O-rings.
- Apply CVTF to the O-rings.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)
Connect the harness connector.
Lower the vehicle.
Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .