LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr580 IMPREZA)) >> Secondary Pressure Sensor >> Removal

Secondary Pressure Sensor: Removal

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
  • When secondary pressure sensor is removed, CVTF leaks. After installing the secondary pressure sensor, adjust the CVTF level.
  1. Disconnect the ground terminal from 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Lift up the vehicle.
  3. Remove the secondary pressure sensor connector.
  4. Remove the secondary pressure sensor.
    G08317807Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals