LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr580 IMPREZA)) >> Inhibitor Switch >> Adjustment

Inhibitor Switch: Adjustment

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Shift the select lever to "N" range.
  3. Loosen the two bolts holding the inhibitor switch.
  4. Insert the ST vertically into the holes of the shifter arm and switch body.

    Preparation tool: 

    ST: STOPPER PIN (499267300)

    G11255606Courtesy of SUBARU OF AMERICA, INC.
  5. Tighten the two bolts holding the inhibitor switch.

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb)

  6. Repeat the inspection of the inhibitor switch. If the inhibitor switch is determined to be "faulty", replace it.
scientia non olet · About LEMON Manuals