LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr580 IMPREZA)) >> Front Differential Assembly >> Assembly >> Side Retainer

Side Retainer

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: After adjusting the backlash and tooth contact, replace the differential side retainer oil seal and O-ring with new parts.
  1. Install the new differential side retainer oil seal using the ST.
    NOTE:
    • Apply differential gear oil to the differential side retainer oil seal lip.
    • Since the differential side retainer oil seal has an identification mark (R or L), be careful not to mix up the RH and LH when installing.

    Preparation tool: 

    ST: DIFFERENTIAL SIDE OIL SEAL INSTALLER (18675AA000)

    G08318154Courtesy of SUBARU OF AMERICA, INC.
  2. Install the O-rings.
    NOTE:
    • Use new O-rings.
    • Apply the differential gear oil to O-ring.
    G08318144Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals