LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr580 IMPREZA)) >> CVTF Cooler (With Warmer Function) >> Removal

CVTF Cooler (With Warmer Function): Removal

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If the CVTF and engine coolant is spilt over exhaust pipe, wipe it off with cloth to avoid emitting smoke or causing a fire.
  1. Disconnect the ground terminal from 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Drain engine coolant. Refer to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT .
  3. Remove the clip from the air intake boot, and loosen the clamp.
    G11252776Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the air intake boot, and place it aside so that it does not interfere with the work.
    CAUTION: Be careful not to pull out the PCV hose.
    G11252777Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the purge hose, purge control solenoid valve harness connector and harness clip.
    G11255715Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the water hose (outlet).
    G11255716Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the CVTF cooler inlet hose and CVTF cooler outlet hose.
    G11255717Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the water hose (inlet).
    G11255718Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the CVTF cooler (with warmer feature) from the transmission.
    G11255719Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals