Inspection Mode C
WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Item | Condition |
|---|---|---|
| P0500 | VEHICLE SPEED SENSOR "A" CIRCUIT | - |
| P0716 | INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT RANGE/PERFORMANCE | - |
| P0717 | INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT NO SIGNAL | - |
| P0970 | PRESSURE CONTROL SOLENOID "C" CONTROL CIRCUIT LOW | - |
| P0971 | PRESSURE CONTROL SOLENOID "C" CONTROL CIRCUIT HIGH | - |
| P0973 | SHIFT SOLENOID "A" CONTROL CIRCUIT LOW | - |
| P0974 | SHIFT SOLENOID "A" CONTROL CIRCUIT HIGH | - |
| P0976 | SHIFT SOLENOID "B" CONTROL CIRCUIT LOW | - |
| P0977 | SHIFT SOLENOID "B" CONTROL CIRCUIT HIGH | - |
| P2746 | INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT RANGE/PERFORMANCE | - |
| P2747 | INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT NO SIGNAL | - |
| P2750 | INTERMEDIATE SHAFT SPEED SENSOR "C" CIRCUIT RANGE/PERFORMANCE | - |
| P2751 | INTERMEDIATE SHAFT SPEED SENSOR "C" CIRCUIT NO SIGNAL | - |
| P2763 | TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT HIGH | After inspection mode A is done, perform inspection mode C |
| P2764 | TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT LOW | - |
Diagnostic procedure:
- Start the engine.
- Check the readiness code using Subaru Select Monitor and confirm that the diagnosis is not completed. Ref. to TRANSMISSION (DIAGNOSTICS) (IMPREZA MODEL)>ALL READINESS DIAGNOSTIC CODE(S) .
- Accelerate slowly to a legal speed, and then decelerate slowly to a stop.
- Check the readiness code using Subaru Select Monitor, confirm that the diagnosis is completed, and end the procedure.