LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (OEM Wiring Diagrams W/ Connector End Views & Fuse/Relay Locations) >> Working Precautions >> Precautions When Working With The Parts Mounted On The Vehicle

Precautions When Working With The Parts Mounted On The Vehicle

WARNING: This page is about a different car, the 2020 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Always refer to "CAUTION" and "NOTE" of "General Description" in the same model's service information before starting the service.
  2. When working under a vehicle which is jacked-up, always be sure to use rigid rack.
  3. The parking brake must always be applied during working. Also, in automatic transmission vehicles, keep the select lever set to the P (Parking) range.
  4. Be sure the workshop is properly ventilated when running the engine.
  5. Be careful not to touch the rotating parts such as a belt or a fan while the engine is operating.
  6. Be careful not to touch hot metal parts immediately after the engine has been turned on or off.
scientia non olet · About LEMON Manuals