V-Belt TENSIONER Assembly

The V-belt tensioner assembly is replaced.
NOTE: When replacing the V-belt tensioner assembly, also perform the following steps.
1. Set the V-belt tensioner assembly to be discarded on a vice.
2. Attach the tool to the V-belt tensioner assembly, and rotate the tool clockwise to remove the ST or 5 mm hex wrench.
Courtesy of SUBARU OF AMERICA, INC.
Install the V-belt tensioner assembly.
Tightening torque:

19 N.m (1.9 kgf-m, 14.0 ft-lb)
Attach the tool to the V-belt tensioner assembly, and rotate the tool clockwise to remove the ST or 5 mm hex wrench.
Install the V-belts. Refer to MECHANICAL (H4DO (EXCEPT FOR HEV))>V-BELT>INSTALLATION>EXCEPT FOR HYBRID MODEL .