Brake Light Lighting Operation Mode By SUBARU Select Monitor
CAUTION:
For models with EyeSight, performing brake light relay compulsory operation may cause the EyeSight warning light to illuminate. If the brake light relay compulsory operation is performed, refer to "Basic Diagnostic Procedure" of "EyeSight (DIAGNOSTICS)" and check DTCs and then clear memory.
- Except for hybrid model: Ref. to EYESIGHT (DIAGNOSTICS) (EXCEPT FOR HEV)>BASIC DIAGNOSTIC PROCEDURE .
- Hybrid model: Ref. to EYESIGHT (DIAGNOSTICS) (HEV)>BASIC DIAGNOSTIC PROCEDURE .
- Using the Subaru Select Monitor, select [Brake Lamp Lighting Operation] from the work support item list.
- Except for hybrid model: Ref. to BRAKE CONTROL (DIAGNOSTICS)>WORK SUPPORT .
- Hybrid model: Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>WORK SUPPORT .
NOTE: In the event of any trouble, brake light lighting operation will not function. - Operate according to the procedures displayed in the Subaru Select Monitor.