Front Brake Pad: Inspection

Check the thickness of the pad - disc brake front.

NOTE:

Always replace the pads of both wheels and both sides as a set.
Replace pad clips if they are twisted or worn.
Replace the pad if there is oil or grease on it.
Wear indicators are installed on the pad - disc brake front inner and the pad - disc brake front outer, and a squeaking sound is heard if the pad is worn to the limit.

Courtesy of SUBARU OF AMERICA, INC.

Brake pad type		Standard (A)	Wear limit (B)
Pad thickness	15-inch type	11 mm (0.43 in)	1.5 mm (0.059 in)
Pad thickness	16-inch type	11 mm (0.43 in)	1.5 mm (0.059 in)

If the wear limit is exceeded in the inspection, replace the pad - disc brake front.