Rear Brake Hose

Route the brake hose through the hole of bracket, and lightly tighten the flare nut to connect brake pipe.
Insert the clamp to secure brake hose.
Tightening torque:

Brake hose bracket: 33 N.m (3.4 kgf-m, 24.3 ft-lb)
Install the brake hose to rear caliper body using a new gasket.
Tightening torque:

Union bolt: 26 N.m (2.7 kgf-m, 19.2 ft-lb)
Turn and tighten the flare nut (b) by hand while pushing the brake pipe (a) away from yourself.
CAUTION: Be careful not to make scratches or other damage to the inside surface of the brake pipe flare.

Tightening torque:

Brake pipe flare nut: 15 N.m (1.5 kgf-m, 11.1 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Bleed air from the brake line.
- Except for hybrid model: Refer to BRAKE>AIR BLEEDING>PROCEDURE>BRAKE LINE (EXCEPT FOR HYBRID MODEL) .
- Hybrid model: Refer to BRAKE>AIR BLEEDING>PROCEDURE>BRAKE LINE (HYBRID MODEL) .
Install the rear wheels.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)