LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center (Service Information) >> Combination Meter >> Installation

Combination Meter: Installation

CAUTION:
  • Make sure the electrical connector is connected securely.
  • Make sure that each meter operates normally.
  • For the model without keyless access with push button start except for C5 model, when the combination meter assembly is replaced, perform the registration of immobilizer. For detailed operation procedure, refer to "Type B" described in "REGISTRATION MANUAL FOR IMMOBILIZER".
  • When the combination meter assembly is replaced, perform the variant work. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER SYSTEM>OPERATION>VARIANT WORK .
  1. Install the combination meter assembly.
  2. Install the visor assembly - combination meter.
  3. Install the grille assembly - CTR ventilation LH.
  4. Install the cover assembly - instrument panel LWR driver.
  5. Connect the ground terminal to 12V engine restart battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: For the hybrid model, connect the battery negative terminal.
scientia non olet · About LEMON Manuals