Meter Pointer Indication Check

In meter pointer indication check, the meter operation, warning/indicator light and LCD/TFT are checked.

1. Press the trip reset switch.
2. After a buzzer sounds for 0.5 seconds and "STEP2" is displayed on LCD/TFT, the meter pointer indication check mode is initiated.
   • Except for hybrid

     Time (sec)	Speedometer (km/h)	Tachometer (r/min)	ECO gauge	Warning light/Indicator light
     1.5	0	0	Lowest point	The following lights are lit.(1) Engine coolant temperature indicator light (blue) Fuel level warning light (near the E mark)(2)
     1.5	0	0	-Max
     1.5	40	1, 000	0
     1.5	100	4, 000	+Max
     1.5	40	1, 000	0
     1.5	0	0	-Max
     (1) Warning lights and indicator lights controlled by other module are turned on/off according to the module control. Ref. to INSTRUMENTATION/DRIVER INFO>GENERAL DESCRIPTION>SPECIFICATION . (2) Model with normal meter

   • Hybrid

     Time (sec)	Speedometer (km/h)	Power meter	Warning light/Indicator light
     1.5	0	Vehicle stop position	The following lights are lit.(1) Engine coolant temperature indicator light (blue)
     1.5	0	Vehicle stop position
     1.5	40	Vehicle stop position
     1.5	100	Vehicle stop position
     1.5	40	Vehicle stop position
     1.5	0	Vehicle stop position
     (1) Warning lights and indicator lights controlled by other module are turned on/off according to the module control. Ref. to INSTRUMENTATION/DRIVER INFO>GENERAL DESCRIPTION>SPECIFICATION .