Flexible Draw Stiffener (tS Model): Installation
- Installation of flexible draw stiffener ASSY
- Install the flexible draw stiffener ASSY with the bolts.
Standard value: T=25N.m {255kgf.cm} {18.4 ft.lbf}
- When using a new flexible draw stiffener.
- Remove the βpin.NOTE: Dispose the removed βpin.
- Remove the βpin.
- When reusing the flexible draw stiffener.
- Rotate the rod so that the rod hole aligns with the housing end surface.
- Tighten the lock nut.
Standard value: T=10N.m {102kgf.cm} {7.4 ft.lbf}
- Install the flexible draw stiffener ASSY with the bolts.
- Installation of undercover COMPL T/M (Refer to INSTALLATION )
- Installation of undercover front AL (Refer to INSTALLATION )