Standard value

WARNING: This page is about a different variant/trim than selected.

Shift position	While idling [MPa {kgf/cm² }]	While stalling [MPa {kgf/cm² }]
D position	0.35 to 0.43 {3.6 to 4.4}	1.20 to 1.38 {12.2 to 14.0}
R position	0.76 to 0.95 {7.7 to 9.7}	1.41 to 1.63 {14.4 to 16.6}

NOTE: When there is an open or short circuit in the line pressure control solenoid ASSY (SLT) system, the line pressure reaches the maximum.

NG: Repair or replacement of transmission valve body ASSY (refer to TRANSMISSION VALVE BODY ASSY )

OK: Go to next step

Check of transmission 3 way solenoid ASSY (S4) system unit
1. Remove the transmission 3 way solenoid ASSY (S4). (Refer to DISASSEMBLY )
2. Check the transmission 3 way solenoid ASSY (S4) unit. (Refer to UNIT INSPECTION )
NG: Replacement of the transmission 3 way solenoid ASSY (S4) (Refer to DISASSEMBLY )

OK: Go to next step
Check of clutch control solenoid No. 1 (SL2) unit
1. Check the clutch control solenoid No. 1 (SL2) unit. (Refer to UNIT INSPECTION )
NG: Repair or replacement of transmission valve body ASSY (refer to TRANSMISSION VALVE BODY ASSY )

OK: Go to next step
Check of transmission valve body ASSY unit
1. Check the transmission valve body ASSY. (Refer to TRANSMISSION VALVE BODY ASSY )
  Criteria: There is no malfunction and foreign objects on the solenoid installation portions.
NG: Repair or replacement of transmission valve body ASSY (refer to TRANSMISSION VALVE BODY ASSY )

OK: Go to next step

Repair or replacement of automatic transmission ASSY (refer to REMOVAL )