Specified resistance (short check)
WARNING: This page is about a different variant/trim than selected.
| Inspection terminals | Inspection conditions | Standard value |
|---|---|---|
| D5-20 and D28-4 - chassis ground | Always | 10 k Ω or more |
- Connect the connector D5 of the main body ECM (network gateway computer).
- Connect the connector D28 of the shift lock solenoid.
NG: Repair or replacement of wiring harness or connector
OK: Go to next step
- Check wiring harness and connector (shift lock solenoid-chassis ground)NOTE: For inspection procedures and precautions, refer to INSPECTION PROCEDURES FOR ELECTRICAL CIRCUITS AND HOW TO PERFORM .
- Disconnect the connector D28 of shift lock solenoid.
- Measure the resistance between the terminals.STANDARD VALUE RESISTANCE SPECIFICATION
Inspection terminals Inspection conditions Standard value D28-5 - chassis ground Always Less than 1 Ω - Connect the connector D28 of the shift lock solenoid.
NG: Repair or replacement of wiring harness or connector
OK: Go to next step
Replacement of the main body ECM (network gateway computer) (Refer to REMOVAL )