Transmission Valve Body ASSY: Installation
WARNING: This page is about a different variant/trim than selected.
- Installation of transmission valve body ASSY
- Insert the spring and the check ball body into the transmission case.
- Make sure that the accumulator piston, spring, and check ball body are installed to the transmission case.NOTE: If the accumulator piston, spring, and check ball body come off, apply auto fluid WS and install them.
- Connect the lever pin to the manual valve hole.
- Install the transmission valve body ASSY with 19 bolts.
Standard value: T=11N.m {112kgf.cm} {8.1ft.lbf}
NOTE: Bolt under head length:- 25 mm {0.984 in} (Bolt A)
- 36 mm {1.417 in} (Bolt B)
- 45 mm {1.772 in} (Bolt C)
- 50 mm {1.969 in} (Bolt D)
- Install the detent spring and detent spring cover with a bolt.
Standard value: T=10N.m {102kgf.cm} {7.4ft.lbf}
- Transmission wire connection (refer to INSTALLATION )
- Installation of valve body oil strainer ASSY (refer to INSTALLATION )
- Installation of transmission oil pan SUB-ASSY (ATM) (refer to INSTALLATION )
- Installation of exhaust pipe SUB-ASSY FR (refer to INSTALLATION )
- Connection of battery ground terminal (refer to INSTALLATION )
- Fill of automatic transmission fluid (refer to ADJUSTMENT )