LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> BRZ tS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle (Service Information)) >> Oil Cooler ASSY >> Installation

Oil Cooler ASSY: Installation

WARNING: This page is about a different variant/trim than selected.
G08554427Courtesy of SUBARU OF AMERICA, INC.
  1. Installation of transmission oil cooler ASSY.
    1. Install the transmission oil cooler ASSY to the oil cooler bracket with 2 bolts.

      Standard value: T=23N.m {235kgf.cm} {17ft.lbf} 

    2. Connect 2 new transmission oil cooler hoses to the transmission oil cooler ASSY with 2 clamps.
    3. Temporarily tighten bolt 1.
    4. Install 2 bolts and tighten them in the order of 2 to 3, with the oil cooler bracket fitted to the vehicle by hand.

      Standard value: T=23N.m {235kgf.cm} {17ft.lbf} 

    5. Tighten bolt 1.

      Standard value: T=23N.m {235kgf.cm} {17ft.lbf} 

  2. Connection of water by-pass hose
    1. Connect 2 water by-pass hoses to the transmission oil cooler ASSY with 2 clamps.
    2. Install a clamp to the both water bypass hoses.
      G08554428Courtesy of SUBARU OF AMERICA, INC.
  3. Connection of transmission oil cooler hose
    1. Connect 2 transmission oil cooler hoses to the transmission oil cooler ASSY with 2 clamps.
      CAUTION:
      • Prevent the clamp claws from interfering with the hoses.
      • Align the painted position of the oil cooler hose until it comes to the center of the hose when viewed vertically from the bracket surface of the oil cooler tube.
      • Prevent the oil cooler hoses and the water bypass hose from interfering with each other or with other parts.
    2. Install a clamp to the positions of the oil cooler hoses shown in the figure.
      G12587500Courtesy of SUBARU OF AMERICA, INC.
  4. Fill of coolant (SUBARU genuine Super Coolant) (refer to COOLANT (FA20) )
  5. Leakage check of coolant (SUBARU genuine Super Coolant) (refer to COOLING SYSTEM (FA20) )
  6. Installation of under cover COMPL T/M (refer to INSTALLATION )
  7. Installation of under cover front AL (refer to INSTALLATION )