On-Vehicle Inspection

Inspection of the turn signal flasher ASSY

Inspection of input/output operation

Measure the voltage between the each terminal of the vehicle wiring harness connector and the chassis ground.

STANDARD VALUE SPECIFICATION - VOLTAGE

Inspection terminals (Terminal symbol)	Inspection conditions	Standard value
D61-4 (+B) - chassis ground	IG OFF	11 to 14 V
D61-1 (IG) - chassis ground	IG OFF →ON	Less than 1 V →11 to 14 V

Measure the resistance between the each terminal of the vehicle wiring harness connector and the chassis ground.

STANDARD VALUE SPECIFICATION - RESISTANCE

Inspection terminals (Terminal symbol)	Inspection conditions	Standard value
D61-7 (GND) - chassis ground	Always	Less than 1 Ω

Courtesy of SUBARU OF AMERICA, INC.

Measure the voltage between each connector terminal and the chassis ground.

Courtesy of SUBARU OF AMERICA, INC.

STANDARD VALUE SPECIFICATION - VOLTAGE

Inspection terminals (Terminal symbol)	Inspection conditions	Standard value
D61-6 (ER) - chassis ground	Turn signal switch (TURN R) OFF →ON	9 V or more →less than 1 V
D61-5 (EL) - chassis ground	Turn signal switch (TURN L) OFF →ON	9 V or more →less than 1 V
D61-8 (EHW) - chassis ground	Hazard switch OFF →ON	9 V or more →less than 1 V
D61-2 (LR) - chassis ground	Turn signal switch (TURN R) OFF →ON	Repeats going from less than 1 V →less than 1 V ←→9 V or more, 60 to 120 times per minute.
D61-3 (LL) - chassis ground	Turn signal switch (TURN L) OFF →ON	Repeats going from less than 1 V →less than 1 V ←→9 V or more, 60 to 120 times per minute.
D61-2 (LR) - chassis ground	Hazard switch OFF →ON	Repeats going from less than 1 V →less than 1 V ←→9 V or more, 60 to 120 times per minute.
D61-3 (LL) - chassis ground	Hazard switch OFF →ON