Unit Inspection
NOTE:
The following procedure is for LH side. The RH side and the LH side inspections follow the same steps.
- Inspection of the rear combination light socket & wiring SUB-ASSY LH
- Inspect if the lights turn on when battery voltage is applied between the connector terminals.BATTERY CONNECTION DESCRIPTION - CRITERIA
Battery connection Criteria Battery positive →1 (B)
Battery ground →2 (E)Tail lights, rear side marker lights Battery positive →3 (STP)
Battery ground → 2 (E)Stop lights turn on. Battery positive → 4 (TL)
Battery ground →2 (E)The turn lights turn on. NOTE: Perform this inspection using new or properly-functioning bulbs.
- Inspect if the lights turn on when battery voltage is applied between the connector terminals.