Checking/Clearing Diagnostic Codes

Preparation before inspection
1. Turn the ignition switch to OFF.
Checking diagnostic codes (reading with SSM4)
1. With IG OFF, connect SSM4 to DLC3.
2. Turn IG to ON, and turn on the SSM4.
3. Operate following the SSM4 display screen. Display [Each System] →[Body Control] screens, and select [DTC].
4. Check the diagnostic codes.
Clearing diagnostic code records (Cleared by the SSM4)
1. With IG OFF, connect SSM4 to DLC3.
2. Turn IG to ON, and turn on the SSM4.
3. Operate following the SSM4 display screen. Display [Each System] →[Body Control] screens, and select [Clear Memory].
4. Inspect the diagnosis codes again, and check that the malfunction code was cleared, and that the normal code is displayed.
  CAUTION:
  - If you can't clear it, start over from IG OFF status.
  - Do not use the SSM4 to delete diagnostic codes until the cause of the trouble has been identified.