Unit Inspection

Inspection of the clock ASSY

Measurement of the resistance of the hazard warning signal switch

Measure the resistance between connector terminals when the hazard warning signal switch is operated.

STANDARD VALUE SPECIFICATION - RESISTANCE

Inspection terminals (Terminal symbol)	Inspection conditions	Standard value
7 (HAZARD+) - 14 (HAZARD-)	Switch OFF	10 kΩ or more
7 (HAZARD+) - 14 (HAZARD-)	Switch ON	Less than 1 Ω

Inspection of LED light (night-time illumination)

Inspect if the LED light turns on when battery voltage is applied to each connector terminal.

TERMINALS DESCRIPTION - CRITERIA

Inspection terminals	Criteria
Battery positive → 9 Battery ground → 13	Light turns on.

Courtesy of SUBARU OF AMERICA, INC.