Stop Light Switch: Installation
CAUTION:
Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to CAUTION
.
.
- Install the stop light switch assembly onto the bracket pedal COMPL with screws and position it with the nut.
- Adjust the stop light switch assembly position, and then tighten the nut. Ref. to BRAKE>STOP LIGHT SWITCH>ADJUSTMENT .
Tightening torque:
8 N.m (0.8 kgf-m, 5.9 ft-lb)
- Install the knee airbag module.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the cover LWR driver.
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY>GROUND TERMINAL REMOVAL OR INSTALLATION .