LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) >> Ambient Sensor >> Removal

Ambient Sensor: Removal

  1. Disconnect the ground cable from battery. Refer to NOTE>NOTE>BATTERY .
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Lift up the vehicle.
  3. Remove the under cover - front. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  4. Remove the bracket center lower - front.
    1. Remove the screw and clips, and turn over the mud guard - front.
    2. Remove the bolts and clips, and remove the bracket center lower - front.
      NOTE: While entirely pushing the bracket center lower - front forward, remove the two hooks (a) on the left and right.
    G10270303Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the ambient sensor.
    1. Disconnect the connector.
    2. Release the claws and remove the ambient sensor.
G12454490Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals