LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Emission Control Systems (Aux. Emission Control Devices) (Except For STI)) >> Purge Control Solenoid Valve >> Removal >> Purge Control Solenoid Valve 2

Purge Control Solenoid Valve 2

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover. Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>COLLECTOR COVER>REMOVAL .
  2. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  3. Remove the brake vacuum pump. Refer to BRAKE>BRAKE VACUUM PUMP>REMOVAL .
  4. Remove the bolt which secures the solenoid valve bracket from the intake manifold.
    G09479941Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the nut which secures the purge control solenoid valve 2 to the solenoid valve bracket.
    G09479946Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the connector (A) and vacuum hose (B) from the purge control solenoid valve 2, and remove the purge control solenoid valve 2.
    G09479947Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals