DTC P2610: ECM/Pcm Engine Off Timer Performance: Notes
WARNING: This page is about a different variant/trim than selected.
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>CLEAR MEMORY MODE>OPERATION
, and inspection mode Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>INSPECTION MODE>PROCEDURE
..
- CHECK DTC.
Read the engine DTC using the Subaru Select Monitor or general scan tool. Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>READ DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC other than P2610 displayed? (Current malfunction)
Yes: Check DTC using "List of Diagnostic Trouble Code (DTC)". Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
No: Replace the ECM. Refer to FUEL INJECTION (FUEL SYSTEMS) (EXCEPT FOR STI)>ENGINE CONTROL MODULE (ECM) .
NOTE: The soaking timer IC is built into the ECM.