LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Fuel Injection System (Except For STI)) >> Oxygen Sensor Relay >> Removal

Oxygen Sensor Relay: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Remove the instrument panel lower cover. Refer to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .
  3. Remove the nut and bolt, and move the fuse block downwards.
    G09475594Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the oxygen sensor relay from the relay block.
    G09475595Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals