LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Fuel Injection System (Except For STI)) >> Fuel Insulator >> Removal >> Fuel Pipe Insulator No. 3

Fuel Pipe Insulator No. 3

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Remove the intake manifold. Refer to FUEL INJECTION (FUEL SYSTEMS) (EXCEPT FOR STI)>INTAKE MANIFOLD>REMOVAL .
  3. Disconnect the connector (A) from the EGR control valve.
  4. Remove the bolts (B) securing the EGR cooler to the EGR control valve.
  5. Remove the preheater hose (C) from the EGR control valve.
    G09479651Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the EGR control valve.
    G09479652Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector (A) on the fuel pressure sensor, and remove the fuel pipe insulator No. 3.
    G09479653Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals