LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Fuel Injection System (Except For STI)) >> Camshaft Position Sensor >> Removal >> Intake Side

Intake Side

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Remove the air intake duct. (RH side only) Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>AIR INTAKE DUCT>REMOVAL .
  3. Disconnect the connector (A) from the camshaft position sensor, and remove the camshaft position sensor from the chain cover.
    • RH side
      G11264982Courtesy of SUBARU OF AMERICA, INC.
    • LH side
    G09479737Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals