CROSSMEMBER And Cushion Rubber
WARNING: This page is about a different variant/trim than selected.
- Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
- Install the transmission cushion rubber to the center crossmember, and temporarily tighten the nut (B).
Tightening torque:
Bolt (A)
35 N.m (3.6 kgf-m, 25.8 ft-lb)
- Install the front crossmember and rear crossmember.
- Tighten the transmission cushion rubber mounting nut.
Tightening torque:
T1: 70 N.m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N.m (14.3 kgf-m, 103.3 ft-lb)
T3: 35 N.m (3.6 kgf-m, 25.8 ft-lb)
- Remove the transmission jack.
- Install the center exhaust cover.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Install the center exhaust pipe (rear). Refer to EXHAUST (EXCEPT FOR STI)>CENTER EXHAUST PIPE>INSTALLATION .
- Lower the vehicle.
- Connect the ground terminal to battery sensor. Refer to NOTE>NOTE>BATTERY .