Transmission Case: Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the manual transmission assembly from the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT) (TY75)>MANUAL TRANSMISSION ASSEMBLY>REMOVAL .
- Remove the clutch release lever and the release bearing. Refer to CLUTCH SYSTEM>RELEASE BEARING AND LEVER>REMOVAL .
- Remove the transfer case together with the extension case assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT) (TY75)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>REMOVAL .
- Remove the bearing mounting bolt.
- Remove the main shaft rear plate.
- Remove the bolts and nuts, and separate the transmission case into the right and left cases.
- Remove the drive pinion shaft assembly.NOTE: Use a hammer handle, etc. to remove if too tight.
- Remove the main shaft assembly.
- Remove the front differential assembly.
- Remove the differential side retainers and taper roller bearing outer races on the left and right sides. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT) (TY75)>FRONT DIFFERENTIAL ASSEMBLY>REMOVAL .NOTE: Do not confuse the right and left taper roller bearing outer races.
- Remove the reverse idler gear. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT) (TY75)>REVERSE IDLER GEAR>REMOVAL .
- Remove the shifter fork and rod. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT) (TY75)>SHIFTER FORK AND ROD>REMOVAL .
- Remove the front oil guide.