Tooth Contact Of HYPOID Driven Gear
WARNING: This page is about a different variant/trim than selected.
Check tooth contact of hypoid driven gear as follows: Apply a thin uniform coat of red lead on both teeth surfaces on 3 or 4 teeth of the hypoid driven gear. Move the hypoid driven gear back and forth by turning the transmission main shaft until a definite contact pattern is developed on the hypoid driven gear, and judge whether face contact is correct. When the contact pattern is not correct, adjust. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT) (TY75)>FRONT DIFFERENTIAL ASSEMBLY>ADJUSTMENT .
- Tooth contact is correct.