LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Manual Transaxle & Differential (TY751)) >> Front Differential Assembly >> Disassembly >> Differential Case Assembly

Differential Case Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Loosen the twelve bolts and remove hypoid driven gear.
    G13261628Courtesy of SUBARU OF AMERICA, INC.
  2. Drive out the straight pin from differential assembly toward hypoid driven gear side.
    ST 899904100 STRAIGHT PIN REMOVER
    G05003108Courtesy of SUBARU OF AMERICA, INC.
  3. Pull out the pinion shaft, and remove the differential bevel pinion, differential bevel gear and adjusting washer.
    G13261630Courtesy of SUBARU OF AMERICA, INC.
  4. Using the ST, remove the taper roller bearing.
    ST 899524100 PULLER SET
    G08548755Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals