LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (CVT Transaxle) >> Transmission Mounting System >> Removal >> Transmission Rear Crossmember And Rear Cushion Rubber

Transmission Rear Crossmember And Rear Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Lift up the vehicle.
  3. Remove the center exhaust pipe (rear). Refer to EXHAUST (EXCEPT FOR STI)>CENTER EXHAUST PIPE>REMOVAL .
  4. Remove the center exhaust cover.
    G12448281Courtesy of SUBARU OF AMERICA, INC.
  5. Set the transmission jack under the transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
  6. Remove the transmission rear crossmember.
    G09481950Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the rear cushion rubber.
    G09481952Courtesy of SUBARU OF AMERICA, INC.